Both the VEW1 and VEW2 type windposts span vertically between floors and the design will usually include a positively fixed base and a top fixing that will allow differential movement between the structure and the masonry.
GA windposts are usually designed as ‘simply supported beams’ with a maximum allowable deflection of span/360 and a maximum allowable design stress of 193.75N/mm2 (includes +25% allowance for transient windload). Where deflection is the limiting factor windposts may be designed as a ‘propped cantilever’, using this method reduces the deflection of the windpost considerably but requires a much larger baseplate.
In most cases parapet posts are required to carry a uniformly distributed load along its height but in some instances it is necessary to consider a point load or a combination of both u.d.l. and point load acting on a post, this may be the case when designing spandrel posts in particular.
GA parapet posts are designed as ‘cantilevers’ with a maximum allowable deflection of span/180 and a maximum allowable design stress of 193.75N/mm (includes +25% allowance for transient windload).
CONNECTION BASEPLATE DESIGN
Windposts which have been designed as ‘propped cantilevers’ and parapet posts which are designed as ‘cantilevers’ require larger baseplates than standard windposts designed as ‘simply supported beams’ this is due to the moment induced on the base connection. Care should be taken when detailing the posts to ensure that the baseplate thickness and fixing bolts used are able to resist the bending moment and that the structure is large enough to accept the larger baseplate and bolts. For further advice please contact GA Fixings technical department.
TOP CLEAT DESIGN
Wherever possible the top cleat connection from the post to the structure should include the provision for differential movement between the structure and the masonry. GA windposts usually include twin vertical slots in the top of the post which allow the top cleat to move vertically yet restrain the post laterally.
Windpost ties are provided at 225mm centres on the VEW1 type posts and 450mm centres at the VEW2 type posts as standard. All parapet posts are supplied with ties at 225mm centres. Slot centres may be changed to suit customer requirements. The relative centres ensure that the capacity of the windpost is matched by the capacity of the ties.