Call us on 01226 380779 | info@gafixings.com

TPT Two Part Ties

Two part general-purpose wall tie used in small commercial buildings and domestic properties. Suitable for buildings with a maximum height of 15m and cavity widths from 150-375mm. The Vista two part tie allows larger cavities to be spanned. (Type 2 Wall Tie)

Downloads

Code	Size	Cavity	Units	DOP
TPT-300-STST	300mm	151-175mm	200 box	–
TPT-325-STST	325mm	176-200mm	200 box	–
TPT-350-STST	350mm	201-225mm	200 box	–
TPT-375-STST	375mm	226-250mm	100 box	–
TPT-400-STST	400mm	251-275mm	100 box	–
TPT-425-STST	425mm	276-300mm	100 box	–
TPT-450-STST*	450mm	301-325mm	100 box	–
TPT-475-STST*	475mm	326-350mm	100 box	–
TPT-500-STST*	500mm	351-375mm	100 box	–

*Type 2 load equivalency may be achieved by increasing the tie density, please contact us for further information.

Application – A general-purpose wall tie for applications such as small commercial buildings and domestic properties. They are suitable for buildings with a maximum height if 15m and for flat sites where the basic wind speed is up to 31m/s and altitude is not greater than 150m above sea level.
Design – As a result of problems experienced over wider cavities (150mm to 375mm) and their weight causing long ties to overturn, the two part tie allows larger cavities to be spanned, (up to BS EN 845 – 1 standard for a type 2 tie). The shorter section is built into the inner leaf as construction proceeds, whilst the longer section is locked into the inner section and built into the outer leaf as it lifts.
Material – Manufactured from grade 304 stainless steel.
Behaviour in relation to fire – Non combustible (as defined in the national Building Regulations).
Durability – Excellent corrosion resistance and a service life of not less than 60 years.
Compliance – Tested as Type B (sound) and as Type 2 (strength) to BS EN 845-1.

TPT Two Part Ties

Downloads

GA Fixings