Call us on 01226 380779 | info@gafixings.com

Neutras-4 low thermal conductivity wall ties

NEUTRAS-4 light duty wall ties have both low thermal conductivity and high structural performance levels. This means they can be excluded from the current U value calculations in EN ISO 6946 and provide a credible solution to new legislation requirements. Suitable for buildings with a maximum height of 10m and cavity widths up to 175mm. (Type 4 Wall Tie)

Downloads

Code	Cavity	Units	DOP
Neutras-4-200	75mm	250 pack	–
Neutras-4-225	100mm	250 pack	–
Neutras-4-250	125mm	250 pack	–
Neutras-4-275	150mm	250 pack	–
Neutras-4-300	175mm	250 pack	–

BBA Approved cavity wall ties (Agrément Certificate: 17/5462).
Application – A light duty wall tie used in box-form domestic dwellings that have inner and outer leaves of a similar thickness. They are suitable for buildings with a maximum height if 10m and for flat sites where the basic wind speed is up to 27m/s and altitude is not greater than 150m above sea level.
Design – Constant drip spiral feature to prevent moisture travelling across the cavity, it can be installed either way up.
Material – Manufactured from continuous basalt fibre and vinyl ester resin composite.
Durability – Service life of not less than 60 years.
Thermal performance – In situations where thermal losses through ties need to be taken into account, the products will adequately resist thermal transmittance through a wall cavity.
Compliance – Tested as Type B (sound) and as Type 4 (strength) to BS EN 845-1.

Neutras-4 low thermal conductivity wall ties

Downloads

GA Fixings